Instruction Manual

62
12) Remove the recoil spring from its seat in the
bolt (fig. 39).
13) Extract the trigger guard pin from the stock-
receiver unit, thrusting it from right or left
with the point of the same firing pin or
punch (fig. 40).
14) Press the carrier button and extract the
trigger guard assembly towards the front
(fig. 41).
WARNING: when the pistol grip stock is instal-
led on the shotgun the stock must be loosened
before the trigger guard assembly can be remov-
ed from the receiver. To do this partially
unscrew the stock retaining nut; thus making it
possible to detach the pistol grip stock from the
receiver to provide the space necessary for
removing the trigger guard assembly.
The shotgun is now completely stripped. All the
parts that require routine maintenance and
cleaning are disassembled.
Shotgun assembly
For correct assembly after cleaning and mainte-
nance operations, proceed as follows:
1) Grip the stock-receiver assembly and press
the carrier button, insert the complete trigger
guard assembly - with cocked hammer - in
the receiver, positioning its frontal part up to
the stop (fig. 42) and insert the trigger guard
assembly completely in the receiver (fig. 43).
2) Push the trigger guard pin into the receiver
from the right or left, until it is completely
inside (fig. 44).
WARNING: when the pistol grip stock is instal-
led on the shotgun the stock must be tightened
after the trigger guard assembly has been
installed in the receiver. Completely tighten the
stock retaining nut until it solidly contacts the
shotgun receiver.
39
40
41
43
42