Instruction Manual

60
Shotgun stripping
(for cleaning and maintenance)
Before starting any operation on your shotgun,
make sure that the chamber, carrier and the
magazine are unloaded!
(Carefully read the instructions on gun loading
and unloading).
Stripping procedure
1) Open the bolt by pulling back the cocking
lever (fig. 19) until the bolt is locked open.
Should the bolt fail to engage, move the car-
tridge drop lever as arrowed and repeat the
operation (fig. 6).
2) Pull the cocking lever off with a firm tug (fig.
27).
3) Unscrew the fore-end cap and remove from
magazine tube (fig. 28).
4) While resting the stock against your hip, grab
the stock-receiver unit with a hand and the
barrel-cover-fore-end unit with the other
hand (fig. 29). Pull the latter forward and
completely off the tube magazine (fig. 30).
5) Rotate the barrel-cover-fore-end unit in the
direction shown by the arrow (fig. 31) and
separate it from the barrel by pulling it out of
the barrel guide ring (fig. 32).
27
28
29
30
32
31