Instruction Manual

6) Take the stock-receiver-bolt unit with one
hand and with the other hand take hold of the
previously formed barrel-breech-fore-end
unit. Slide the fore-end down the magazine
tube, making sure that the cover goes over the
magazine tube (fig. 10) and that it is properly
centered on the receiver so that the bolt unit
can be properly seated (fig. 11) and the bar-
rel-breech-fore-end unit is pushed all the
way in (fig. 12) (that is, until you cannot push
it further and the assembly clicks against
metal and the cover adheres perfectly to the
receiver (fig. 13).
7) Screw the fore-end cap all the way onto the
end of the tubular magazine (fig. 14). Fasten
it tightly so that the barrel-cover unit is firmly
seated against the receiver (fig. 13).
8) Insert completely the cocking lever into the
bolt unit (fig. 15).
9) Close the bolt by pressing the special carrier
control button (fig. 16).
55
11
12
13
14
16
15