Instruction Manual

54
10
8
9
7
5
6
NOTE: the carton piece is only used for pack-
ing. It must not be reinstalled on the gun.
3) Remove the red plastic bolt clip from its seat
in the receiver (fig. 5).
NOTE: the red plastic clip is used to retain the
bolt during shipping only. It must not be reinstall-
ed on the gun.
4) Take the stock-receiver-bolt unit with a hand;
with the other hand, using the cocking lever,
bring the bolt into open position (until lock-
ed) (fig. 6).
WARNING: should the bolt fail to engage, move
the cartridge drop lever as arrowed and repeat
the operation (fig. 7).
During the following operations the bolt group
should be completely assembled and placed in
the receiver, in open position (backward).
5) Install the fore end on the barrel-breech unit.
The fore end must first be slid over the barrel
guide ring (fig. 8) and then snapped onto the
barrel (fig. 9).