User Manual

Before starting any operation on your shotgun,

make sure that the chamber and the magazine

are unloaded!

(Carefully read the instructions on gun loading

and unloading).

NOTE: make sure that your firearm is fitted with

a magazine tube containing a number of car-

tridges permitted by legislation in the country

where you intend to use it.

Loading procedure

NOTE: make sure that the shotgun safety catch

(see “Gun safety catch”) is engaged and the

hammer cocked (so that the carrier latch can

retain the cartridges as they are inserted in the

magazine).

WARNING: for safety reasons, check if by open-

ing the bolt the shotgun is unloaded. Then close

the bolt again.

1) Make sure that the red dot on the cartridge

drop lever (indicating that the hammer is

cocked) is clearly visible (fig. 13). If it is not,

press the carrier button (a), open the bolt (b)

then close the bolt again (c) (fig. 14).

2) With the bolt closed and the hammer cocked,

reverse the gun pointing the barrel down-

wards.

3) Insert a cartridge into the magazine (fig. 15):

push it until it is retained by the carrier latch

which engages automatically (fig. 16).

Repeat the operation until the magazine is

fully loaded.

NOTE: the gun must be loaded with the hammer

cocked so that the carrier latch can retain the

cartridges as they are inserted in the magazine.

Now the gun cannot be fired unless a cartridge

is placed in the barrel, as to one of the following

procedures: