User Manual

3) Use an Allen key to remove the rubber plug

from the sling attachment hole inside the

stock (fig. 71).

4) Using a 3 mm diameter punch as a tommy

bar, screw the sling attachment pin into the

hole in the stock. Tighten into firm contact

with stock, until the hole in the pin lies per-

pendicular to the line of the stock (fig. 72).

5) Fit the comfort kit “2” and then the butt plate

to the stock (see fig. 57).

Changing the front sight

On shotguns with a carbon fibre rib, the red fibre

optic front sight can be changed for the yellow or

green fibre optic sight supplied.

Proceed as follows to change the front sight.

1) Use the tip of a flat blade screwdriver to prize

up the sight mounting and remove it from its

seat in the rib (fig. 69).

2) Insert the chosen sight into the seat in the rib,

pressing hard until it clicks securely into

place (fig. 70).

Fitting the sling attachment

pin to the stock

Shotguns with wooden stocks come with a sling

attachment pin. Proceed as follows to fit this to

the stock.

1) Unscrew the two fixing screws using a

Phillips screwdriver and remove the butt

plate “1” (see fig. 57).

WARNING: smear the tip of the screwdriver

with Vaseline or grease to avoid damaging the

stock.

2) Using the same Phillips screwdriver, unscrew

the two fixing screws and remove the com-

fort kit “2” from the stock (see fig. 57).