User Manual

Adjusting the back-sight
For the adjustment of the back-sight as illustrated
in figure 60, proceed as follows:
1) Using the wrench provided, slacken the two
sight screws.
2) Adjust the sight position as desired (move it
to the left if you want the point of impact to
move left or move it to the right if you want
the point of impact to move right) and fully
tighten the two screws.
Proceed as follows to carry out the back-sight
adjustments as shown in figures 61, 62, 63 and
64:
A - Lateral adjustment
By means of the relative screw, set the sight
position as desired (move it to the left if you want
the point of impact to move left or move it to the
right if you want the point of impact to move
right) by adjusting it according to the graduated
alignment notches.
B - Vertical adjustment
By means of the relative screw, set the sight
position as desired (in the “up” anticlockwise
direction if you want to raise the point of impact
or in the opposite direction if you want the point
of impact to be lower) by adjusting it according
to the graduated alignment notches.
21
63
62
64
60
61