User Manual

To remove the limiter proceed as follows:
1) With the gun unloaded, point the barrel up-
wards. Using the index finger of your hand,
remove the limiter retaining from the mag-
azine tube (fig. 50).
To facilitate removal, rest your right thumb on
the magazine tube and turn the retaining ring
until one of the tabs passes the magazine tube
spigot (fig. 51).
2) Hold the limiter and retaining ring and allow
them to be forced out of the magazine by the
magazine spring.
3) Completely remove limiter and retaining ring
from magazine.
To install the limiter, proceed as follows:
1) With the gun unloaded, point barrel upwards
and insert the limiter into the appropriate fit-
ting hole (fig. 52).
2) Take the limiter retaining ring in your hand
and position it on the limiter. Ring should be
positioned at a slight angle (fig. 53).
3) Push the limiter into the magazine tube,
ensuring that the retaining ring enters properly
(fig. 54).
Keeping the ring positioned at a slight angle
will enable it to slip into the magazine tube
entirely, even though it is wider than the tube
bore.
4) Reduce finger pressure until the limiter is tight
against the tube spigot (fig. 55).
19
50
51
52
53
55
54