User Manual

Magazine capacity can be increased to four 2
3/4 inch or 3 inch cartridges by removing the
plug as follows (fig. 47):
1) Unscrew and remove the magazine cap by
turning it counter clockwise.
2) Remove the barrel to prevent accidental
scratching of the finish.
3) Insert and hold a screwdriver blade into the
opening in the magazine tube to capture the
spring and retainer when they are released.
CAUTION: the magazine spring and retainer
are under pressure inside the magazine tube
and will fly out with considerable force. Use
caution to avoid injury.
4) Using a pair of snap ring or needle-nose
pliers, squeeze the retaining ring together.
The spring pressure will allow it to come out
of the tube and slide up the screwdriver shaft.
5) Remove the retainer and spring from the
magazine tube.
6) Point the magazine tube downward so the
limiter will slide out. Remove the limiter only.
The cup shaped plastic follower must remain
in the magazine tube (closed end facing the
receiver) for proper feeding.
7) Insert the spring into the tube.
8) Slide the retaining ring onto the screwdriver
shaft with the cupped side facing away from
the handle.
9) Insert the screw driver blade into the spring
and slowly compress it into the magazine
tube.
10) Push the retainer against the mouth of the
magazine tube.
Tap the end of the screwdriver handle to push
the retainer into the magazine tube until it is
flush with the end of the tube.
11) Re-install the barrel.
12) Screw on the magazine cap and hand-
tighten.
13) Check to be sure that the barrel is fully seated
against the receiver.
17
47