User Manual

14
3) Push the action release lever. The action
should unlock.
4) Move the forearm fully rearward and then
fully forward. It should move freely and lock
again in the closed position.
5) With the safety in the “on” (“safe”) position,
pull the trigger. The hammer should not fall.
6) Move the safety button to the fire position
(red ring visible) and pull the trigger. The
hammer should fall and the action should
unlock.
7) Cycle the action again by moving the forearm
fully rearward and then fully forward.
Check to be sure the bolt locks properly. Pull
the trigger. The hammer should fall. Open
the action fully.
WARNING
Follow all safety instructions regarding place-
ment of the safety in the “on” position and keep-
ing the muzzle pointed in a safe direction.
ACCESSORIES AND ADJUSTMENTS
Drop and cast adjustment
(where expected)
Before beginning any operation on your shot-
gun, always make sure that chamber and
magazine have been completely emptied!
(Carefully read loading and unloading instruc-
tions).
The shotgun is supplied with a “drop change kit”
(fig. 39) which enables you to adjust the original
drop the shotgun is supplied with. The kit con-
sists of one stock locking plate (in steel), plus
drop change shims three (plastic).
The kit enables you to obtain four different drop
patterns (as specified in the following table) and
two different deflections (right hand or left hand).
Each unit is marked with the corresponding
drop and cast letter.
Determine if your stock drop fits you perfectly, or
whether it is either too high or too low for you.
If it is too low, you need to select the previous
adjustment set in alphabetical order (e.g. if the
shim supplied on the shotgun is marked with a
“C”, you must select the “B”, together with the
corresponding stock locking plate).
39
Matching instructions: the drop change shims and
stock locking plates in the kit are identified by letters.
To ensure a correct drop, always use plates and shims
with the same letter, e.g.: C - CDX – for a 65-RH drop
or C - CSX – for a 65-LH drop.
DX = Right hand
SX = Left hand
DROP CHANGE SCHEDULE
Cast Stock Drop
shim locking plate shim
(plastic) (steel) (plastic)
Reference Reference Reference
letter letter letter
DX Z DX
Z
50 ± 1 DX
SX Z SX 50 ± 1 SX
DX A DX
A
55 ± 1 DX
SX A SX 55 ± 1 SX
DX B DX
B
60 ± 1 DX
SX B SX 60 ± 1 SX
DX C DX
C
65 ± 1 DX
SX C SX 65 ± 1 SX
Drop value
at heel (mm)