User Manual

If they are not, the trigger group will not seat
properly (fig. 35).
14) Be certain the hammer is fully cocked in the
trigger assembly.
15) Insert the front end of the trigger guard in the
front of the receiver opening, and then swing
the rear portion downward until the assembly
locks into position.
Do not force (figs. 36-37).
16) Insert the trigger group pins (longer pin in
front) through the receiver until the large
heads are flush with the sides (fig. 38).
Function Testing
Whenever the firearm is reassembled, a brief
function test should be conducted before firing
to insure that all parts and safeties are assembl-
ed correctly and functioning properly.
WARNING
Visually and physically check the chamber, car-
rier and magazine to be sure no ammunition is
present. Keep the firearm pointed in a safe
direction at all times.
1) Put the safety in the “on” (“safe”) position
and close the action by moving the forearm
fully forward. The action should move
smoothly with binding.
2) Without activating the action release lever,
pull rearward on the forend. The action
should remain locked and should not open.
13
33
34
35
36
38
37