User Manual

WARNING

When the pistol grip or telescopic stock is instal-

led on the shotgun the stock must be loosened

before the trigger guard assembly can be remov-

ed from the receiver. To do this partially unscrew

the pistol grip stock retaining nut or the telesco-

pic grip retaining ring nut; thus making it possible

to detach the pistol grip stock or the telescopic

stock grip from the receiver to provide the space

necessary for removing the trigger guard

assembly.

7) Turn the shotgun over so the receiver opening

is facing down and slide the forearm fully

rearward. Insert your thumb inside the re-

ceiver from the bottom and push the bolt

upward against the top inside of the receiver

to separate it from the action bars (fig. 24).

8) Compress the bolt assembly by squeezing the

bolt head and body together with thumb and

index finger and pull the bolt up and out of the

receiver (figs. 25-26).

9) Remove the forearm assembly by sliding it for-

ward and completely off the magazine tube

(fig. 27).

Firing Pin Removal

CAUTION: the firing pin is under spring pres-

sure from the firing pin return spring when

assembled in the bolt.

To prevent loss or possible eye injury, depress

and hold the rear of the firing pin with your

thumb or finger.

Pull the stop pivot pin (with rubber “O” ring)

out from the bolt, and gradually release pressu-

re on the firing pin until spring pressure is

relieved. The firing pin and spring can now be

completely removed from the rear of the bolt

(figs. 28-29). Your shotgun is now disassembled

for routine cleaning or maintenance.

NOTE

Further disassembly of the trigger group assembly

is not recommended unless you are a trained

gunsmith.