User Manual

10
Disassembly Procedure
Barrel
1) To remove the barrel, unscrew the magazine
tube cap (fig. 19); by turning it counter-
clockwise.
2) Depress the action release locking lever and
pull the forend partially rearward to release
the bolt from the barrel extension.
3) Holding the barrel, pull it forward along the
magazine tube until the ring clears the tube.
Lift the barrel slightly up and away from the
magazine tube and slide it forward (fig. 20).
Trigger Assembly Group
4) Using the peg on the end of the magazine
tube cap, start pushing the trigger guard pins
out from the right side (ejection port side) of
the receiver.
Using the open inside edge of the magazine
tube cap, hook the heads of the pins now
protruding from the left side of the receiver.
Pull them completely out of the receiver
(figs. 21-22).
NOTE: the larger of the two pins fits the front
hole and the smaller, the rear.
5) Rotate the shotgun so the trigger guard is
facing upward.
6) Remove the trigger guard assembly by pul-
ling the trigger guard upward and away from
the bottom of the receiver (fig. 23).
20
19
21
22
24
23