Parts List

English
32
ASSEMBLING THE PISTOL
Proceed as follows.
– Insert the bolt inside the breech and make
sure the guide lugs are inserted in the guides
(figure 41-42-43).
Important
When inserting the bolt, make sure that the
bolt end (return spring bush) slides under the
guard retaining pin inside the breech (figure
44). Figure shows the weapon upside down.
– Place the bolt locking support in its seat in the
breech. Push it slightly backwards to align it
properly in its seat and press all the way down
until it snaps into place (figure 45-46-47).
– Check if the hammer is cocked. If not, cock it
(figure 48).
– Insert the guard with the seat
(A) aligned
with the retaining pin
(B) inside the breech
(figure 49-50).
– Insert the guard all the way into its seat in
the breech and place the pin (figure 51).
–
MP 90S Turn the pin clockwise until the end
of the thread (the pin will be idle) and lower
the lever (figure 51).
–MP 95E Insert the guard retaining pin (from
right or from left) and push it until it is com-
pletely inside the breech (figure 51).
– Make sure there are no projectiles in the
magazine.
– Insert the magazine into its seat (figure 52).
Caution - Warning
A loaded magazine (one or more projectiles)
can ONLY be inserted if the firearm will be
used straight after this operation. This is nec-
essary as to avoid risks connected to leaving
the pistol loaded.
475-003-0.fm Page 32 Thursday, August 26, 2010 1:52 PM