Parts List

English
31
– Remove the magazine clip by pushing on the
button (figure 31).
– Pull the bolt back and block it open the bolt/
slide and lock it into that position by pushing
on the stop button (figure 32).
– Remove the pin-protection spacer for 'dry
firing' (if mounted) (figure 33).
–MP 90S Raise the lever and, from the oppo-
site side of the breech, press on the pin and
at the same time use the lever to turn it
counterclockwise until it is pulled off (figure
34).
–
MP 95E Using the appropriate punch, pull
out the guard retaining pin (figure 34).
– Rotate the trigger guard downwards and ex-
tract it by pulling it (figure 35).
– Grasp the locking head and pull it off (figure
36-37).
– Pull the bolt back until it is free of the
breech's guide slots and pull the bolt off (fig-
ure 38-39).
Once the procedure is completed, the pistol is
completely stripped and ready for maintenance
and/or adjustment operations.
MAINTENANCE OF THE FIREARM
The following list includes the maintenance op-
erations to be performed after each use of the
firearm.
– Strip the pistol (See "Stripping the pistol").
– Clean the barrel.
– Periodically clean powder and residues from
the trigger assembly and then lubricate it
lightly.
– Periodically clean powder and residues
from the bolt assembly and then lubricate it
lightly.
– Reassemble the pistol (See "Assembling the
pistol").
– Make sure there are no projectiles in the
magazine. This is necessary as to avoid risks
connected to leaving the pistol loaded.
– Carefully clean all the outer surface of the
firearm and place it in its case.
Important
We recommend Benelli Armi oil to lubricate
the components of the firearm (figure 40).
475-003-0.fm Page 31 Thursday, August 26, 2010 1:52 PM