Parts List

English
29
CHANGING THE PISTOL WEIGHT
The firearm is supplied with an empty weight
support.
To change the weight of the firearm, perform
the following operations on the weight sup-
port.
Remove the weight support by unscrewing,
with the special tool, its screw (figure 13-14).
To increase the weight of the firearm, ballast
the internal compartments of the weight sup-
port, and assemble it back on the gun, fasten-
ing the screw tightly (figure 15).
GRIP ADJUSTMENT (MODEL MP 90S)
To change the distance between grip and trig-
ger, remove or add the spacer.
– Unscrew the mobile palm support fastening
screw (figure 16).
– Remove the mobile palm support (figure 17).
– Remove the fastening pin (figure 18).
– Unscrew the grip fastening nut and pull it off
the grip together with its washer (figure 19).
– Pull the grip off (figure 20).
To decrease the distance, pull off and re-
move the spacer (figure 21).
To increase the distance, insert the spacer in-
side the grip.
– Assemble the grip (figure 22).
– Insert the washer onto the fastening part
(figure 23-34).
– Insert and screw the fastening part, together
with the washer, inside the grip (figure 25).
– Looking through the slot, check that the fas-
tening part and washer have remained in
their proper assembly position (figure 19).
Important
Take care not to over tighten the fastening
nut as the grip might be spoiled.
– Insert the mobile palm support fastening pin
into the grip, being careful to align the
threaded hole with the grip slot (figure 26).
– Reassemble the mobile palm support and fas-
ten it by tightening its screw (figure 27-28).
475-003-0.fm Page 29 Thursday, August 26, 2010 1:52 PM