Parts List

English
27
TRIGGER ASSEMBLY ADJUSTMENT
(MODEL MP 95E)
The firearm trigger assembly is supplied with
factory settings.
To adjust the assembly, remove the trigger
guard assembly from the weapon (See "Strip-
ping the pistol").
Figure 6 shows the parts to be used to carry out
the settings.
Hammer release pressure adjustment
– Turn screw (A) to adjust the hammer release
pressure.
– Clockwise: the hammer release pressure in-
creases.
– Counterclockwise: the hammer release pres-
sure decreases.
Changing the FREE TRAVEL (trigger stop) of the
trigger
– Turn screw (B) to change the travel length.
– Clockwise: the free travel of the trigger (after
the round is fired) shortens, while the travel of
the second portion of the pull increases
– Counterclockwise: the free travel of the trig-
ger (after the round is fired) lengthens, while
the travel of the second portion of the pull de-
creases.
An excessive turning of screw prevents the
hammer from being released.
An excessive turning of screw cancels the sec-
ond portion of the pull and abnormally
lengthens the free travel of the trigger (after
the round is fired).
REAR SIGHT ADJUSTMENT (MODEL
MP 90S)
Sight APERTURE adjustment (figure 7).
– Turn screw (A) to change the width of the sight.
– Turning screw (A) towards the (+) sign increas-
es the width of the sight; turning towards the
(–) sign decreases it.
Sight aperture ELEVATION adjustment (figure 8).
– Use lever (B) to change the elevation of the
sight.
– Moving lever (A) towards the (+) sign increases
the elevation of the sight aperture; turning to-
wards the (–) sign decreases it.
475-003-0.fm Page 27 Wednesday, June 20, 2012 4:13 PM