User Manual

WARNING: if firing pin and relative locking pin
have been correctly assembled, at the end of the
operation the firing pin will appear as described
under fig. 63.
NOTE: do not use any tools to insert the firing
pin into the bolt carrier: use fingers only.
10) Hold the stock receiver almost horizontally
and insert the bolt assembly in its guide on
the receiver (fig. 64).
11) Insert completely the cocking lever into the
bolt group (fig. 65).
WARNING: make sure that the link slides over
the trigger guard assembly and onto the recoil
spring plunger inside the receiver once the bolt
assembly is fully mounted (fig. 66).
12) Open the bolt (fig. 67).
13) Press the cartridge drop lever (fig. 68).
Complete gun reassembly by following procedu-
res listed from point 4 at page 7 “Assembly pro-
cedure”.
19
65
64
63
68
66
67