User Manual

4) Lift the stock-receiver group as far as the

receiver and press the carrier button, insert

the complete trigger group - with cocked

hammer - on the receiver in slightly forward

position, then draw it back until engaged in

the rear of the receiver itself (fig. 57).

5) Block the trigger guard assembly using the

trigger guard pin (fig. 58).

6) Insert the bolt head into the front of the bolt

carrier (the hole on its leg must be aligned

with the slot of the bolt) (fig. 59).

7) Insert the locking head pin in its hole on the

locking head’s stem, through the slot on the

bolt (fig. 60).

NOTE: the reference line on top of the pin must

be visible and aligned with the bolt assembly

longitudinal axis.

8) Insert the firing pin and the firing pin spring

inside the bolt (fig. 61).

NOTE: always make sure that the firing pin

spring has been mounted.

9) Insert the locking pin stud in its seat (fig. 62).