User Manual

1) The red dot on the cartridge drop lever (indi-
cating that the hammer is cocked) (fig. 15)
must be clearly visible. To bring lever to this
position, press the carrier button and open
the bolt by hand, then bring it to close posi-
tion again (fig. 16).
2) With the bolt closed and the hammer cocked,
reverse the gun pointing the barrel down-
wards.
3) Insert a cartridge into the magazine (fig. 17):
push it until it is retained by the carrier latch
which engages automatically (fig. 18). Repeat
the operation until the magazine is fully load-
ed.
NOTE: the gun must be loaded with the hammer
cocked so that the carrier latch can retain the
cartridges as they are inserted in the magazine.
Now the gun cannot be fired unless a cartridge
is placed in the barrel, as to one of the following
procedures.
A) direct procedure:
1) Open the bolt (fig. 19) and at the same time
insert a cartridge into the barrel through the
case ejection port (fig. 20).
2) Release the cocking lever: the bolt will push
the cartridge on the carrier into the chamber
and stop in the closed position.
9
19
20
18
16
17
15