User manual

8
C. Inner Tube Housing Spring Replacement
WARNING! For spring removal, the following operations must be carried out carefully in order to prevent the
magazine spring(s) from escaping at high speed. When carrying these operations out, always wear eye protection. If a
magazine spring escapes at high velocity, severe eye injury or other injuries with serious consequences can occur. The
same care must be taken during spring installation.
Within the XRAIL System inner tube housing, there are four magazine tube springs: one main tube spring held in with a
threaded cap (the long cap) and three auxiliary springs held in with threaded caps (the shorter caps). The recommended
steps for replacing all magazine springs is following the picture diagrams 1-5 below.