User manual

6
4. Maintenance
WARNING! Before starting any operation on gun, make sure that the gun chamber and magazine are UNLOADED
and the safety is engaged!!
A. Barrel Removal (See diagram C). To remove barrel: 1. Loosen side angle set screws. 2. Loosen side set screws. 3.
Remove barrel clamp screws. 4. Remove barrel clamp. 5. With bolt in locked open position, slide barrel out of receiver…
angle barrel upwards to remove rest of the way. 6. Note: Connection between XRAIL System and M2 receiver should be
tight. During the factory install process, we seal this connection with Loctite. If it comes loose, do not reinstall barrel
until you consult an RCI technician for the proper resealing process…doing so could damage the connection. At this point
you can maintain bolt as described in the Benelli Manual.