Manual

25
GB
Shotgun assembly after cleaning
Following routine maintenance and/or clean-
ing, the shotgun should be reassembled as
follows:
1) Hold the stock-receiver assembly with
your left hand and, keeping the carrier
release pressed with the left-hand
thumb, insert the complete trigger
guard assembly- with the hammer
cocked - inside the receiver with the
right hand, positioning it so that its
front is in contact with the receiver
(fig. 37).
2) Push the trigger guard pin bush into
the receiver (fig. 38) and insert the
trigger guard assembly completely in
the receiver (fig. 39).
3) Push the trigger guard pin bush into
the receiver from the right or left, until
it is completely inside (fig. 40).
4) Place the bolt recoil spring in its seat
on the bolt (fig. 41).
5) Slide the locking head into the bolt,
making sure that the hole on its stem
coincides with the slot on the bolt (fig.
42).
Note: the slanted surfaces on the
locking head’s stem should not be vi-
sible once the bolt locking head is
mounted.
6) Insert the locking head pin in its hole
on the locking head’s stem, through
the slot on the bolt (fig. 43).
Make sure that the reference line on
top of the pin is visible and aligned
with the bolt’s centerline (fig. 43).
7) Insert the firing pin and the firing pin
spring inside the bolt (fig. 44).
Note: always make sure that the firing
pin has been inserted together with
its spring.
8) Insert the firing pin retaining pin in its
seat, so as to block the firing pin (fig.
45).
Note: the firing pin and its retaining
pin are properly mounted only if the
firing pin is visible, as shown in fig. 46.
WARNING: improper assembly of the
bolt group can cause accidental dis-
charge resulting serious injury or
death. Ensure that the assembly of the
bolt group is completed in the speci-
fied order and that the rear of firing
pin is visible at the back of the bolt.
If the rear of the firing pin is not visi-
ble, reassemble the bolt group accord-
ing the procedure shown in the ma-
nual, taking special care that the rear
of the firing pin is clearly visible at
the rear of the bolt carrier. Do not
use tools to insert the firing pin into
the bolt carrier; use fingers only.
9) Hold the stock-receiver assembly al-
most vertical with your right hand and
insert the bolt assembly in its guide on
the receiver (fig. 47), making sure that
the link slides over the trigger guard
assembly and onto the recoil spring
plunger inside the receiver once the
bolt assembly is fully mounted (fig.
48).
10) Open the bolt by pulling back from
the locking head face (fig. 49) until the
bolt is locked open.
If the bolt doesn’t lock open, push the
cartridge drop lever in the direction
shown by the arrow (fig. 4) and repeat
the previous step.
11) Bring the cover nexy to the receiver,
slightly ahead of the bolt (fig. 50).
12) Slide the cover backward over the
bolt, keeping it pressed close to the re-
ceiver, until it comes to a resting posi-
tion against the receiver (fig. 51).
13) Push the bolt lever into its hole on the
bolt until it fits snugly (fig. 52).
14) Finish assembling the shotgun by fol-
lowing all the steps (except the first
three) outlined under the section
“Assembly of Packaged Gun” page 20.