User manual

MPTP | MPTP commands 97
Check Command format from 4.6.8
The special fields of the command are as follows:
Setting ID
Field Description Range
2500 GPRS usage Defines if GPRS is used or not. Default
1
0=disabled
1=enabled
2501 USER ID Defines the ID used in GPRS
communications
0-24 character
2502 Service Number Defines the Service number for MPTP
messages used in GPRS backup
0-24 character
2503 IP address Defines the Gateway IP address.
Default TWIG Server.
15 characters
2504 Server port Defines the gateway port
0…5 numbers
2505 GPRS APN Defines the Access point name to
GPRS, if needed
0-24 character
2506 User name Defines password to connection is
needed
0-24 character
2507 Password Defines password for connection if
needed
0-24 character
2508 Int Roaming block Defines the GPRS data block in
roaming networks. Default 1
0=disable
1=enable
2509 Reconnect int Defaults the GPRS connection
reconnection interval. Default 10
0-99
2510 Connection mode Defines how the GPRS connection to
server is kept active. default 1
0=only reconnect
1=when in charger
2=always
4.6.18. Settings 2550–2557 –Assistance call numbers
Defines the Assistance call numbers for voic call and SMS. Settings can be sent in same message with
limitation of 5 settings or total length of message 160 chacaters depending which is met first.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Protector SW CG1P.01.001.0000