User manual
MPTP | MPTP commands 96
Check Command format from 4.6.8
The special fields of the command are as follows:
Setting ID
Field Description Range
2440 Alerts when Defines the orientation/environment when
the alarm is detected
1=Horisontal
2=Vertical
3=No
movement
2441 Sensor usage Define the operating mode of the sensor.
Default 0.
Note that it can not be active
simultaneously with GPS motion
sensor control
0=disabled
1=enabled
2442 No Alarm
duration
Defines the interval how long the condition
“Alerts when” must be active before the
state is confirmed and entered to pre alarm
mode. Default 30
0-65534
seconds
2443 Pre alarm
duration
defines the interval how long pre alarm is
active before SOS is activated. Default 30
0-65534
seconds
2444 Motion sensibility Defines the acceleration value what is
used when defining the movement for
alert. Default 100
20-999 mG
2445 Man Down Angle Defines the tilt angle the phone must fall,
before the mode is detected as “fallen”
Default 45
0-90
2446 Activate only in
idle
Defines if the Man Down Alert is active
only when the unit is in IDLE. Default 0
0=disabled
1=enabled
4.6.17. Settings 2500–2510 –GPRS Settings
Defines the General GPRS settings. Note, that also CNF 0300-0302 are supported . Settings can be
sent in same message with limitation of 5 settings or total length of message 160 chacaters depending
which is met first.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Protector SW CG1P.01.001.0000
•