User manual

MPTP | MPTP commands 87
2006
MPTP header
translation
Defines if MPTP command headers are
changed from ? to Q and ! to E. Needed in
some countries due to SMSC functions.
0=disabled
1=enabled
( translate)
2007 automatic answer Defines if call from any number is
automatically answered. Discards whitelist
call check. Default 0
0=disabled
1=enabled
2=block all
incoming calls
2008 Power off disabled Defines if the power key can be used to turn
off the device. Default 0 ( power off allowed)
0..1
2009 Power saving mode Defines the power saving mode. 0=disabled,
1=medium, 2= heavy. Default ( no power
saving
0..2
4.6.9. Settings 2020–2021 -GPS Settings
Defines the GPS related settings. Settings can be sent in same message with limitation of 5 settings or
total length of message 160 chacaters depending which is met first. (CNF2022 requires GPS FW 2.3 and
FW CG1P.01.019.0000 or later, CNF2023-2024 requires SW CG1P.01.022.0000 or later )
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Protector SW CG1P.01.001.0000
Check Command format from 4.6.8
The special fields of the command are as follows:
Setting ID
Field Description Range
2020 GPS sleep time Defines the sleep time of the GPS in basic
mode Default= 600
0-65534 sec
2021 GPS max search
time
Defines how long the position is tried before
going to sleep. Default 300
120-600 sec
2022 AGPS usage Defines if the unit requests assistance data
via GPRS gateway. 0= disabled, 1=enabled,
default 0
0-1
2023 GPS motion sensor
control
Defines if motion sensor is used to control
GPS. If set to on, movement higher than
defined in CNF2024 turns GPS on, if Sleep
interval has passed. Default = 0 (disabled).
Note this function can not be used
simultaneously with Man Down alert
0-1
2024 Sensitivity Defines in mG value the accelaration level,
that must be exceeded to wake the GPS
from sleep. Default 20
20-100 mG