User manual
MPTP | MPTP commands 82
User ID Defines the ID number of the device.
Number must be same as used in the
backend. Typically own phonenumber
If the number is not set, the backend server
cannot identify the transmissions
String of 0…40
digits
Service number Defines the Service Number that is used
incase the GPRS connection fails and SMS
is defined as backup. Only Twig Discovery.
If the number is not defined SMs backup on
the messaging will not be used.
String of 0…21
digits
Connection
mode
Defines the Connection mode in GPRS
telematics use.
0: Only GPRS
1: Only SMS
2: GPRS if available, otherwise
SMS
0…2
International
roaming block
Defines if GPRS operation in telematics is
allowed when roaming.
0: not allowed
1: allowed
0…1
Hearbeat
interval
Defines the interval for hearbeat message
sent via GPS to backend server in minutes.
max. 60 min. 0 means that the heartbeat is
switched off. Default value is 10
0, 1…60
Reconnect
Interval
Defines the interval for how frequently the
unit shall do GPRS re-connect in minutes,
max. 65534 min. 0 means that the
reconnecting is disabled. Default value is 10
0, 1…65534
Response Wait
time
Defines the max time for waiting the
response message, in seconds. Range 0…
10 s. Default value is 10.
0…10
Maximun
number of
resends
Defines the max number or resends if the
response message is not received. Range
0…5. Default value is 1
0…5
4.6.5. Setting 0301: GPRS Telematics APN
This command is used to set the APN (access point name), Username and password of the Internet
connection needed for GPRS telematics function.