User manual
MPTP | MPTP commands 80
be overwritten.
Authorized
number N
Authorized phone number N. valid phone
numbers
As up to 20 authorized numbers can be defined; the length of one MPTP message may not be enough to
hold the whole persistent setting configuration. Normal rules for concatenating persistent setting
configuring commands – described in section 4.6 – allow a command to be broken down over several
messages in this case.
There is a setting called White list use which defines whether this list of authorized numbers is used or not.
4.6.3. Setting 0060: GPS operating mode
This command is used to set the GPS operating mode. This setting can be overridden temporarily for
example when position request is received and position needs to be updated but the GPS operating
mode is Off.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Locator SW 2.06
•
Twig Protector SW CG1P.01.001.0000
•
Command format
Command*
Part number*
Setting ID
GPS operating
mode
4 1 5 1 4 1 1
?CNF _ 01/01 _ 0060 _ 1
*) cf. section 3.1 for description of this field.
The special fields of the command are as follows:
Field Description Range
Setting ID Numeric identifier of the setting being
configured. In this case, the ID is 0060.
0000…9999
GPS operating
mode
GPS operating mode:
0: off
1: full power
3: economy / low power
0, 1, 3