User manual

MPTP | MPTP commands 72
Command format
Type 0
Length: 21...42 characters
Command*
Part number*
Type
Status
Battery level*
Sent messages
Accessory data
4 1 5 1 1 1 1…2 1 4 1 1…5 1 1…15
!ASR _ 01/01 _ 0 _ 0 _ 075% _ 20 _ 123456789
*) cf. section 3.1 for description of these fields.
The special fields of the command are as follows:
Field Description Range
Type Type of the reporting process, which sent
the report. Cf. section 4.5.5.
Currently there is only one type of process.
0
Status Status of the device
0 = Device is working normally
1 = <TBA>
0…99
Sent messages Total number of messages sent since the
process was activated
1…65534
Accessory data This field may be omitted totally if there is no
data to be added to the field. Note that also
the previous underscore is left away if this
field is not added to the message.
This field is meant to hold data about some
accessory that has been attached into the
device. The format of the data depends on
the accessory in question.
1…15 chars
4.5.8. SW version and IMEI request (?SIR)
CC MTT
The SW version and IMEI request command can be used by a Control Centre to request a Mobile
Telematics Terminal to send a report containing its IMEI code and information about the software
versions it is running.