User manual

MPTP | MPTP commands 70
Field Description Range
Type Type of the automatic status reporting
process.
Currently there is only one type of process
and 0 should be used in this field always.
0
Service state Activity of process. Value 1 should be used
when activating the process; otherwise the
process will not be activated.
See chapter 4.5.6 for deactivating the
automatic status reporting process.
0…1
Interval Time between sending of automatic status
reports reports (cf. 4.5.7), in minutes.
1…65534 (min)
4.5.6. Deactivating automatic status reporting
CC MTT
The automatic status reporting deactivation command is sent by a Control Centre to make the receiving
Mobile Telematics Terminal deactivate automatic status reporting process created with the automatic
status reporting request command described above, ?ASR.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Discovery Pro SW CD1P.02.019.00000
Twig Discovery Pro (Tracer) SW CD1R.02.054.0000
Twig Discovery Pro (Navigation) SW CD1Q.02.054.0000
Twig Discovery Pro (Tracer, Navigation) SW CD1S.02.054.0000
Reception
Upon receiving an automatic status reporting deactivation command, the receiving instrument should stop
the reporting process with the type specified in the request.
Depending on the authorization of the Control Centre which requested the deactivation, the reporting
process may be stopped at once or the request may be disregarded altogether. Cf. section 2.1.3 for more
information.