User manual

MPTP | MPTP commands 65
4.5.3. Device information report (!INF)
MTT CC
The device information report command can be sent by a Mobile Telematics Terminal to inform a Control
Centre about the status of the instrument. It is always sent automatically when a condition programmed
for it is met.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Discovery Pro SW CD1P.02.047.00000
Twig Discovery Pro (Tracer) SW CD1R.02.054.0000
Twig Discovery Pro (Navigation) SW CD1Q.02.054.0000
Twig Discovery Pro (Tracer, Navigation) SW CD1S.02.054.0000
TWIG Protector SW CG1P.01.001.0000
TWIG Locator SW CL1L.06.014.000?
Sending
This command is automatically sent when an event, which has been programmed to trigger it, occurs.
Such events can include the battery charge level being low, the battery being too cold or warm, or the
instrument being connected to or disconnected from a charger. The report is sent to the number
configured as Service center number (cf. section 2.1.3).
To configure the use of this report, cf. below.
Command format
Length: 111...145 characters
Command*
Part number*
Mode*
Battery level*
Position source*
Position format*
Position*
Time stamp*
Speed*
Heading*
4 1 5 1 4 1 4 1 3 1 1 1 24 1 19 1 7 1 6 1
!INF _ 01/01 _ norm _ 032% _ gps _ 1 _ N60.26.54,3_
E022.17.37,1
_ 11.07.2003
_09:57:46
_ 142km/h _ 275deg _
Status code
Status text
Battery
temperature
Battery
capacity
Failure code
Time of sending
3 1 0…15 1 3…5 1 1…5 1 1…2 1 19
004 _ Battery low _ 20.0 _ 900 _ 0 _ 11.07.2003
_09:58:03