User manual

MPTP | MPTP commands 56
Passcode Passcode entered into the query by the
user.
The code is not verified locally. Any
verification needs to be done based on this
field by the Control Centre.
This field is omitted if the query which
caused sending the report did not require a
code, or if the user failed to enter one.
Currently not used. Defaults to 0
0…4 chars
4.3.2. Condition check report interactive mode (!CND)
MTT CC
The condition check report command is sent by a condition check process running on a Mobile Telematics
Terminal. The condition check process, with any of the trigger types, can either be set up locally or in
interactive mode. Interactive mode (CND) must be acknowledged.. The same kind of report is used for all
trigger types.
Supported Twig instruments and SW versions: Send Receive
Twig Protector SW CT1P.01.019.0000
Sending
This command can be sent by a condition check process. Cf. section 4.3 for more information.
Command format
Length: 94...111 characters
Command*
Part number*
Trigger type
Interval
Service state
Mode
Battery level*
Position source*
Position format*
Position*
Time stamp*
4 1 5 1 1 1 1…5 1 1 1 4 1 4 1 3 1 1 1 24 1 19 1
!CND _ 01/01 _ 0 30 _ 1 _ emer _ 075% _ gps _ 1 _ N68.28.43,9
E027.27.02,4
_ 28.10.2003
14:36:35
_