User manual

MPTP | MPTP commands 46
*) cf. section 3.1 for description of this field.
The special fields of the command are as follows:
Field Description Range
Trigger type Trigger type of tracking process to be
deactivated, as defined in section 4.2.1.5.
To deactivate all tracking processes at once,
trigger type 99 can be used.
0…9, 99
Service state Activity of tracking process. Value 0 should
be used; otherwise the process will not be
deactivated.
0…1
4.2.2. Tracking reports
A tracking process will always send one or more tracking reports when it has been started. The type of
report sent depends on process:
Simple process, interval in minutes (!TRC) :
The report described in section 4.2.2.1 is used. Cf. section 4.2.1.1 for information on how this kind
of a process is created.
Simple process, interval in seconds (!TRS) :
The report described in section is used. Cf. section 4.2.1.2 for information on how this kind of a
process is created.
Complex process (!TRG) :
The report described in section 4.2.2.3 is used. Cf. section 4.2.1.4 for information on how these
kinds of processes can be created.
The various report types are described in the sections below.
4.2.2.1. Simple report: interval tracking, minutes (!TRC)
MTT CC
These tracking report commands are sent by a simple tracking process, with interval given in minutes,
running on a Mobile Telematics Terminal. The tracking process can be remotely set up by using the
command described in section 4.2.1.1. Esc! also allows setting up the process locally.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Hunter SW CD1H.02.002.00000 Hunter 1.0.3
Twig Discovery Pro SW CD1P.02.047.00000
Twig Discovery Pro (Tracer) SW CD1R.02.054.0000
Twig Discovery Pro (Navigation) SW CD1Q.02.054.0000
Twig Discovery Pro (Tracer, Navigation) SW CD1S.02.054.0000
Twig Locator SW 2.06