User manual
MPTP | MPTP commands 37
Time limit Stop trigger condition: the tracking process is
stopped after it has been running for the time
set in this field.
1…65534 (min)
4.2.1.4.4. Trigger type 3: stopping at date and time
CC → MTT
A type 3 tracking process sends reports at regular intervals until a specified date and time is reached.
Such a process can be created and activated by a Control Centre, by sending a complex tracking
request command with trigger type 3.
The tracking process has the following properties:
• Start trigger : None.
The tracking process is started as soon as it is created.
• Interval
The process will send tracking reports at the specified interval until the stop trigger condition is
met. The interval is given in full minutes.
• Stop trigger : Date and time.
The tracking process is stopped when the specified date and time is reached.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Discovery Pro SW CD1P.02.047.00000
•
Twig Discovery Pro (Tracer) SW CD1R.02.054.0000
•
Twig Discovery Pro (Navigation) SW CD1Q.02.054.0000
•
Twig Discovery Pro (Tracer, Navigation) SW CD1S.02.054.0000
•
Twig Protector SW CG1P.01.001.0000
•
Reception
Depending on the authorization of the Control Centre which sent the request, a new tracking process may
be created or the request may be disregarded altogether. Cf. section 2.1.3 for more information.