User manual

MPTP | MPTP commands 32
Interval : Interval for sending reports while outside the area, in minutes.
Stop trigger : Arrival at area; i.e. reversing the start trigger condition.
1. Report while inside the area :
The tracking process sends reports while the Mobile Telematics Terminal is inside the area. The
tracking process parameters are in this case as follows:
Start trigger : Arrival at area.
Interval : Interval for sending reports while inside the area, in minutes.
Stop trigger : Departure from area; i.e. reversing the start trigger condition.
2. Report arrival :
The tracking process sends a single report when the Mobile Telematics Terminal arrives at the
area. The tracking process parameters are in this case as follows:
Start trigger : Arrival at area.
Interval : Only one report is sent. However, the interval set here is used in case the GPS
needs to be switched on. Cf. below for more information.
Stop trigger : Immediate; the process is stopped as soon as the single report has been
sent.
3. Report departure :
The tracking process sends a single report when the Mobile Telematics Terminal departs from
the area. The tracking process parameters are in this case as follows:
Start trigger : Departure from area.
Interval : Only one report is sent. However, the interval set here is used in case the GPS
needs to be switched on. Cf. below for more information.
Stop trigger : Immediate; the process is stopped as soon as the single report has been
sent.
4. Report arrival and departure :
The tracking process sends a single report when the Mobile Telematics Terminal arrives to or
departs from the area. The tracking process parameters are in this case as follows:
Start trigger : Arrival to or departure from area.
Interval : Only one report is sent. However, the interval set here is used in case the GPS
needs to be switched on. Cf. below for more information.
Stop trigger : Immediate; the process is stopped as soon as the single report has been
sent.
An area tracking process remains active even after its stop trigger condition has been met. It will be
automatically restarted if the start trigger condition is met again. To deactivate a process so that it will not
start again, use the command described in section 4.2.1.4.7.
Supported Benefon/TWIG instruments and SW versions: Send Receive
Twig Discovery Pro SW CD1P.02.047.00000
Twig Discovery Pro (Tracer) SW CD1R.02.054.0000
Twig Discovery Pro (Navigation) SW CD1Q.02.054.0000
Twig Discovery Pro (Tracer, Navigation) SW CD1S.02.054.0000
Twig Locator SW 2.06
Twig Protector SW CG1P.01.001.0000