Owner`s manual

100 GSM MENU: MESSAGES
If you wish to delete all the messages displayed in
this list, select the option
Delete all with n and
press
- OK. Confirm the deletion by pressing -
OK again, or cancel the operation by pressing .
NO.
READING AND PROCESSING AN
INCOMING MESSAGE
1. Highlight the desired message with n, and
press
- SELECT.
2. By scrolling with
n, you are able to read the
whole message.
3. To process the message, press
- SELECT.
•Select the desired function with n and
press
-.
4. If you do not want to process the message,
press
. QUIT to return to the previous menu
level.
Reply
Use this option if you wish to send a message back
to the sender. That way, you do not need to key in
the phone number or recall it from phone book.
Write and edit the text as follows:
•To remove letter(s), press
. CLEAR shortly.
•To add letters into text, press
2...9.
•To add special characters into text, press
0 for
a few seconds. Use
n to select a line and then
press the numeric key, which corresponds to the
desired character.
•To enter a space, use
+.
•To move inside the text, press
n.
•You may also modify the text with the T9 text
input tools (for further information about using
the T9 text input, please see the chapter Main
menu, Accessories, Notepad, Writing a note in
T9 mode).
When the message is written, press
- SELECT to
send, save or postpone it.
If you do not want to go further, press
. QUIT to
cancel the operation and return to the message
processing list.
Sending and saving the message
You have four options to choose from: send and
save, send only, send with position, and postpone.
Select an option with
n and press - OK.