User`s manual

CONFIGURATING LOCATOR
31
in yymmdd hhmmss format, e.g. 080101
120000
.
Config 35: Power on interval
When timer is set on, power on interval
defines the time interval at which Locator is
subsequently turned on.
The power on interval can be set between
00.00.00 (hh.mm.ss) and 99.59.59 (hh.mm.ss).
Default value is
00.00.00 which means that the
interval is not in use.
Config 36: Power off delay
When Locator is powered on by power key,
timer, acceleratation sensor, or connecting
charger, power off delay defines the time after
which Locator is automatically shut down.
The power off delay can be set between
00.02.00 (hh.mm.ss) and 11.59.59 (hh.mm.ss).
Default value is
00.05.00 (five minutes).
Config 37: Accelometer sensitivity
This setting defines the allowed acceleration
when Locator is powered on, in 10*mG for-
mat. The value can be set to 0-10. Note that
when the value is set to 0 (zero), the acce-
lometer is off.
Exceeding the allowed acceleration sends an
!INF message to the number defined in Alarm
number 1 field in configuration settings.
Config 38: Accelometer duration
Defines the time for how long motion needs to
endure, to power Locator on. The value can be
set to 1-250 seconds. Default value is 3 sec-
onds.
If motion stops before Locator is powered on,
the accelometer duration is reset. if motion is
starts again, counting duration starts from the
beginning.
Config 39: Man down mode
Defines man down alert mode. Set the value
as following:
0 = Launches man down alert when hori-
zontal condition is met.