User`s manual

CONFIGURATING LOCATOR
30
to use international phone numbers, write the
plus sign (+) and a country code in front of
the number. Or use national phone numbers
without the plus (+) and the country code.
When a call is initiated, Locator starts calling
to the first defined phone number (Field 28).
If the call can be established to this number,
there will be no attempts to another numbers.
If the call cannot be established to the first
number, the second number is called instead.
The cycle will go on until one of the phone
numbers answer the call.
Note that outgoing voice calls can be initiated
only if there is at least one voice call number
defined.
CONFIGURATION SETTINGS 33-48
Config 33: On/off timer
On/off timer defines whether timer, charger
timer, or accelerator sensor are activated in
your Locator or not.
On/ off timer value can be set to:
• 0 (zero): Timers are not in use.
•
1 : Timer mode is activated.
Note that turning Locator off by power key,
dismisses all timers even when on/ off timer is
set on.
Config 34: Startup time
If timer is set on, startup time defines the
first activation time to be used. Define the
value in the format yymmdd hhmmss, UTC
time. If the set value is invalid, it is consid-
ered as 0 (zero), and automatically set to cur-
rent time (the
time on which
Locator is
turned on for
the first time
after this set-
ting is saved)
+ the defined
power on
interval.
Define the
start-up time