User`s manual

CONFIGURATING LOCATOR
28
can be set to: 00.00.10 ... 00.59.59 (hh.mm.ss).
Default value is
00.30.00 (thirty minutes).
Config 13: GPS update in Tracking mode
You can define time interval for GPS position
updates in the tracking mode. Valid values are
between:
00.00.10 ... 00.59.59 (hh.mm.ss).
Default value is
00.10.00 (ten minutes).
Config 14: GPS update in Anchor mode
You can define time interval for GPS position
updates in the anchor mode between:
00.00.10 ... 00.59.59 (hh.mm.ss). Default value
is
00.01.00 (one minute).
Config 15: Max. allowed movement in Anchor
mode
You can define a maximum distance that
Locator is allowed to move from the original
position in the anchor mode. Once the limit is
exceeded, a movement alarm is triggered.
Allowed distance can be set to:
0100 ... 9999
meters. Default value is 0300 (300 meters).
Config 16: Battery alarm level
Locator can alert you when its battery level is
declined under certain level. You can define
the alarm level at
20 , 40 , or 60 percentage of
full battery charge. Default value for the
alarm is
20 percent. If the value is set to 00 , it
means that the alarm is deactivated.
Note, that battery levels can vary substan-
tially when using Timer modes with long OFF
periods. This may cause wrong or repeating
Low battery alarms.
CONFIGURATION SETTINGS 17-32
Config 17: !IND messages
You can define whether !IND messages can be
sent or not. A !IND message is sent when
anchor alarm is activated by pressing the
anchor button.
The default value for !IND messages is
NO . If
you wish to enable sending !IND messages,
change the setting into
YES .