User`s manual

CONFIGURATING LOCATOR
25
Config 2: ID
You can define an identification for your Loca-
tor. This code may contain both numbers and
letters, and it is case sensitive. Default value
for the ID code is:
Locator .
Config 3: Security code
Security code is used when configurating
Locator and activating its different features.
The security code consists of 4 digits. Default
security code is
0000 .
Config 4: Translate header
Translate header defines whether special
characters in the beginning of SMS based
MPTP messages are replaced by letters or not.
The replacement is necessary with some
mobile phone operator systems (e.g. Russian
and China). If Translate header is set to
• YES : The question mark (?) in the beginning
of MPTP requests is replaced by the letter Q.
The exclamation mark (!) in the beginning of
MPTP updates and replies is replaced by the
letter E.
•
NO : Selecting NO restores the original set-
tings for MPTP messages. Question mark (?)
is used in the beginning of requests, and
exclamation mark (!) is used as the start
character for replies and updates.
Default value for Translate header is NO . If the
field is left blank, the default value is taken
into use.
Note that to use Locator with TWIG Discovery
Pro, or some other back-end devices, you
need to make sure that Translate header is
configured correspondingly also in the other
device. If MPTP message start character is
configured differently in the other device,
sending and receiving MPTP messages from
Locator is not possible.
Config 5: Alarm button pressed message
You can create a short message to be included
in MPTP messages sent when Locator’s alarm
button is pressed.
The maximum lenght of this message is 16
characters. Default message is
Alarm button
pressed
.