User`s manual

CONFIGURATING LOCATOR
24
Note that Locator settings are case sensitive.
If available values are YES/ NO, the chosen
setting must be written with uppercase let-
ters. If there are wrong characters, or other
invalid values set in the configuration field,
those are ignored and default value is taken
into use.
You can also restore default settings to your
device by pressing
Set defaults .
CONFIGURATION SETTINGS 1-16
Connect Locator to your computer as
described in
opening connection on page 21 . You
can edit and define several settings, including
security settings and available connections, to
be used with your Locator.
Config 1: PIN Code
PIN code (4 digits) is used to unlock Locator’s
SIM card, unless you are using a SIM card in
which the PIN code is disabled.
Default value for PIN code is
0000 . Replace the
value with your own PIN code, or leave the
field blank if the PIN code has been disabled.
If the PIN
code is
defined incor-
rectly, you
won’t be able
to turn on
your Locator.
After three
failured
attempts, the
SIM card will
be blocked.
If your SIM
card gets
blocked, you need a PUK code (8 digits) to
open it. Remove the SIM card for Locator and
install it into a phone compatible with your
SIM card. When trying to open the phone, it
will prompt you for the PUK code. After enter-
ing the PUK code, key in a new PIN code. You
can then install the SIM card back to Locator.
If you fail to key in the correct PUK code 10
times in a row, your SIM card will be perma-
nently blocked. If this happens, contact your net-
work operator to get a new SIM card.