User`s manual

KEYS, LEDS AND OUTER PARTS
11
3. Charging starts automatically. As a sign of
charging, all three LED indicators are turned
on for a couple of seconds. After that
the
GSM LED blinks in sequences, 2 blinks in a
sequence at first and then 4 blinks in a
sequence. When the battery is fully
charged, the GSM LED stays constantly on
until the charger is disconnected. If there is
an interruption or failure in charging, the
status LED is turned off. Unplugging and
replugging the cable displays the status of
charging. If the battery is full, the status
LED blinks 4 times, after which it is turned
off.
4. You can operate Locator during charging.
However, if the battery is totally empty, it
might take several minutes before the
device can be used. If you turn Locator on
while charging, the LEDs indicate events
related to the ongoing mode, instead of
showing the charging status.
CHARGING ONLY MODE
You can turn your Locator into charging only
mode by connecting the device to charger and
pressing power off key. The device cannot be
used when charging only mode is on.
To cancel the charging only mode and turn on
device operations, press the power key again.
Or, unplug and reconnect the charger without
turning the power off from power key.