Product Manual

LIFT OPERATION SAFETY (CONT’D)

4. Position vehicle for proper weight distribution arms

under vehicle to allow adapters to contact at the

manufacturer’s recommended pick up points.

5. If the specic vehicle lift points are not identied, refer

to the VEHICLE CENTER OF BALANCE instructions

found on our website at:

http://www.bendpak.com/support/balancing-safety/

6. Push the RAISE button or rotate the control switch on

the power unit.

7. Stop before making contact with vehicle. Check arm

restraint pins for engagement. If required, slightly move

arm to allow restraint gear and pawl to mesh. DO NOT

hammer arm restraint pin down as this will damage the

restraint gear teeth.

8. Raise vehicle until tires clear the oor.

9. Stop and check adapters for secure contact at vehicle

manufacturer’s recommended lift points.

MANY SPECIALTY OR MODIFIED VEHICLES

CANNOT BE RAISED ON A TWO-POST FRAME

ENGAGING LIFT. CONTACT VEHICLE

MANUFACTURER FOR RAISING

OR JACKING DETAILS.

Fig. 19.2

TYPICAL LIFTING POINTS

NOTE:

ALLOW (2) SECONDS BETWEEN MOTOR STARTS.

FAILURE TO COMPLY MAY CAUSE MOTOR BURNOUT.

Fig. 19.3