Product Manual

ManualsBrandsBendPak ManualsFilter CrushersRanger Products Oil Filter Crusher

TOOLS / SUPPLIES REQUIRED

Adjustable wrench or metric open end/combination

wrenches, Teflon tape, hammer, drill and bit.

Quick disconnect Air fitting to match your air source.

Bolts and or anchors.

UNPACKING INSTRUCTIONS

1. Use caution when unbolting or unstrapping from

shipping pallet. Components are heavy and may have

shifted during shipping.

ASSEMBLY INSTRUCTIONS

1. Set the unit on a sturdy bench or table that can

support its weight and has provisions for the drain hose

and room for an approved waste oil container below the

crusher.

(Optional Ranger Oil Filter Crusher Stand is available from

your Authorized Ranger Products Dealer. See page 9.)

2. Bolt or lag screw (not provided) the unit to the stand or

table.

3. Thread an appropriate fitting for your air supply into

the air oil regulator. Use teflon tape on the threads.

AN AIR LINE DRYER MUST BE USED ON THE AIR

SUPPLY LINE. FAILURE TO DO SO WILL VOID

WARRANTY AND DAMAGE AIR CYLINDER,

VALVES AND FITTINGS.

4. Connect air supply line using 1/4 inch air hose with

125 -175 p.s.i. maximum.

5. Ensure the drain hose is connected and an approved

waste oil container is in place below the crusher before

proceeding.

MAINTENANCE

 Keep the press clean and free of debris and dirt.

 All exposed machine surfaces of the press

should be brushed clean and wiped with WD-40 or

equivalent.

 Regularly check the air lubricator and water ﬁ lter for

water - drain as required.

 Regularly clean the press chamber to remove any

accumulated sludge, metal particles or other debris that

could affect the press operation.

 Check drain hose for accumulation of debris, and

remove any materials that may be clogging the hose.

 Inspect for leaks and drain the approved Waist Oil

Container in accordance with Local, State and Federal

regulations.

 Apply grease to door hinges on a regular basis to

prevent the door from binding.

 Apply motor oil to door latch pivot points on a regular

basis to prevent latch from binding.

TECHNICAL SPECIFICATIONS

• Overall Height: 29 1/2” / 749 mm. • Chamber Opening Depth: 11” / 279 mm.

• Overall Width: 17” / 432 mm. • Average cycle time: 15-20 seconds

• Overall Depth: 17” / 432 mm. • Air input: 125-175 PSI

• Chamber Opening Height: 10.25” / 260 mm. • Unit Weight: 228 lbs. / 103 kg.

• Chamber Opening Width: 8.25” / 209 mm.