Product Manual

P-9000LT/F Low-Rise Pit Lift 5 P/N 5900022 — Rev. A5 — February 2019
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in injury or death.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in injury or death.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
NOTICE Calls attention to a situation that, if not avoided, could result in product or property
damage.
Tip Calls attention to information that can help you use your product better.
Liability Information
BendPak Inc. assumes no liability for damages resulting from:
• Use of the product for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak Inc.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.
Components
P-9000LT/F components include:
• Console. Hosts the controls for the Lift (on top) and the Power Unit (inside). The connections for
the Hydraulic Lines and the Air Lines connect to the Power Unit inside the Console.
• Power Unit. Provides Hydraulic Fluid to the Hydraulic Cylinders, which they use to raise the
Platforms. Housed inside the Console. Connects to an external power source.
• Long Ramps. Used to drive onto or off of the Platforms. Not included with the P-9000LTF. Install
the Long Ramps on the side opposite the Hinged Ramps.
• Short Ramps. Used to drive onto or off of the Platforms. Not included with the P-9000LTF.
Install the Short Ramps next to the Hinged Ramps.
• Hinged Ramps. Next to the Short Ramp while the P-9000LT/F is on the ground; hinges up when
the Platforms are raised.
• Platforms. Flat steel plates that raise and lower. Platforms have openings for the optional Lift
Arms. The Platforms, or the Lift Blocks on the Platforms, make contact with the undercarriage of
the vehicle in order to raise and lower the vehicle. Each Platform has two square rubber pads,
which are designed to make contact with the undercarriage of the vehicle.
• Bases. The bottoms of the Lift. They hold the Hydraulic Cylinders, Air Cylinders, Safety Locks, the
holes for the Anchor Bolts, and more.
• Frames. The combination of the Platforms, the Bases, and the scissor components. Each P-
9000LT/F is made up of two Frames, four Ramps (not the P-9000LTF), and one Console.