Product Manual

P-9000LT/F Low-Rise Pit Lift 36 P/N 5900022 — Rev. A5 — February 2019
Lift Arm Kit
The P-9000LT/F has an optional Lift Arm Kit available.
The Lift Arms increase the capabilities of your Lift. The pads and extenders let you quickly and easily
hit the lifting points of cars, light trucks, and SUVs. If you are using your P-9000LT/F in a pit
environment, the Lift Arms install over your pit without interfering with your lube bay opening.
The Lift Arm Kit includes:
• Four telescoping Lift Arms
• Four round rubber pads
• Four extensions
• Four Safety Stop Bushings
Together, the Lift Arms can raise up to 9,000 pounds (4,082 kilograms). The Lift Arms are designed to
be used together to raise a vehicle;
do not use the Lift Arms separately .
If you extend the Lift Arms (using their telescoping ability) past four inches from the edge of the
Platform, the rated capacity of the Lift Arms is reduced:
• Up to four inches: 2,250 lbs per Lift Arm, 9,000 lbs total. No reduction in rated capacity.
• At six inches: 1,500 lbs per Lift Arm, 6,000 lbs total.
• At 10 inches: 900 lbs per Lift Arm, 3,600 lbs total.
• At 18 inches (fully extended): 500 lbs per Lift Arm, 2,000 lbs total.
⚠ WARNING Do not overload the Lift Arms. If you try to raise a vehicle that is over the rated
capacity, you could damage the Lift or the Lift Arms. Also, the vehicle could fall,
possibly damaging the vehicle or causing serious bodily injury, even death.
To install the Lift Arms:
1. Move the first Lift Arm into place on top of the Platform, with the non-telescoping end above the
hole on the Platform you want to install it into.
⚠ CAUTION Be careful with the Lift Arms; they are heavy and you can pinch your fingers.
BendPak recommends wearing gloves when installing or moving the Lift Arms.
2. Put the flange on the bottom of the Lift Arm into the hole, then move the Lift Arm over into the
narrower section of the hole.