Product Manual

P-9000LT/F Low-Rise Pit Lift 32 P/N 5900022 — Rev. A5 — February 2019
Add the Ramps
The P-9000LT comes with four Ramps: two Long Ramps and two Short Ramps. The P-9000LTF
does not come with any Ramps, as it is flush mount.
The standard configuration is for the Short Ramps to be installed next to the Hinged Ramps and the
Long Ramps to be installed on the other end of the Base.
This configuration creates a flat,
extended
Platform onto which you drive the Vehicle to be raised. The
extended Platform keeps the Vehicle flat and well above the Platforms that raise the Vehicle, making it
easy to position the Lift Blocks under the vehicle’s manufacturer-recommended Lifting Points.
Not necessarily to scale. Not all components shown. Side view of Base and Ramps.
All four Ramps come with pins that fit into holes in the Base. To put a Ramp into position, put the pins
into the holes in the Base and make sure they are correctly seated.
Final Checklist Before Operation
Make sure these things have been done before using your lift:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Power Unit is getting power from the power source.
• Check the Hydraulic Fluid reservoir; it must be full of approved Hydraulic Fluid or automatic
transmission fluid.
You can harm the motor by running it without enough fluid.
• Check the Hydraulic System for leaks.
• Check to see that all Anchor Bolts are appropriately shimmed and correctly torqued.
• Make sure that all Safety Locks are cleared and free.
Leave the Manual with the Owner/Operator
Make sure to leave the Installation and Operation Manual with the owner/operator so that it is available
for anyone who needs to read it.