Product Manual

P-9000LT/F Low-Rise Pit Lift 26 P/N 5900022 — Rev. A5 — February 2019
Connect the Air Line
The P-9000LT uses air pressure in two ways:
• It helps push the Platforms down. The weight of the vehicle does much of the work, but the Air
Line also helps.
• It moves the Platforms off the Safety Lock, so they can be lowered.
Important: It is the responsibility of the P-9000LT owner to provide an air pressure supply
(minimum 30 psi / 3 CFM, regulated to a maximum of 125 psi).
The air pressure supply is distributed to the Air Cylinders and the Air Lower Connectors using .25 inch
black plastic tubing, which is supplied with the Lift. You need to cut the tubing into appropriate lengths
based on the distance between the components you are connecting. You should need seven tubing
sections.
The following drawing shows how you can route the Air Lines from the Console to the components
that require air pressure.
Drawing not to scale. Some components now shown, other components exaggerated for clarity.
To connect the Air Line:
1. Locate two Straight Compression Fittings and connect them to the connectors at the top of the
Hydraulic Cylinders.
2. Locate two Elbow Compression Fittings and connect them to the connectors on the top of the Air
Cylinders.
3. Locate the black plastic tubing and the three Tee Compression Fittings.
4. Cut the tubing into appropriate lengths for your installation.
Tip BendPak recommends planning out the path of the Air Line before you start cutting
the tubing.