Product Manual

P-9000LT/F Low-Rise Pit Lift 23 P/N 5900022 — Rev. A5 — February 2019
Connect the Hydraulic Lines
Hydraulic Lines provide Hydraulic Fluid to the Hydraulic Cylinders, where it is used to raise the
Platforms.
Note: Hydraulic Lines and Fittings are different from Compression Lines and Fittings.
This section
covers Hydraulic Lines and Fittings only
.
The P-9000LT comes with two Hydraulic Lines, both of which go from a Hydraulic Power Out
connector on the Power Unit to one of the Hydraulic Cylinders.
The following drawing shows the general arrangement of how Hydraulic Lines are routed from the
Power Unit to the Hydraulic Cylinders. The Console is on the left in this drawing.
Drawing not to scale. Some components not shown, other components exaggerated for clarity.
Fittings shown not connected for clarity.
Note: Previous models of the P-9000 Series used Flow Dividers. They are no longer used.
Important: The Hydraulic Line Assemblies, when installed, need to be
angled so that they are up
against or very near to the Hydraulic Cylinders, not standing straight up.
To connect the Hydraulic Lines:
1. If the Platforms are not already on their top Safety Locks, raise them now. It is not possible to
connect the Hydraulic Lines if the Platforms are lowered.
Refer to Lift the Platforms Off the Bases for additional information.
2. Locate four Hydraulic Elbow Fittings, two Hydraulic Lines, and two Hydraulic Line Assemblies.
3. Attach an Hydraulic Elbow Fitting to each of the two Hydraulic Power Out connectors on the
Power Unit, labeled P1 and P2.