Product Manual

P-9000LT/F Low-Rise Pit Lift 18 P/N 5900022 — Rev. A5 — February 2019
Anchor the Bases
Both Bases have six holes in them for anchoring the Base.
Anchor Bolt specifications are:
• Length: 4.75 inches
• Diameter: ¾ inch
• Effective embedment depth: 2.75 inches, minimum
• Anchor torque: 110 – 150 foot pounds
⚠ WARNING Only use the factory-supplied parts that came with your lift . If you use
parts from a different source, you void your warranty and compromise the safety of
everyone who installs or uses the Lift.
The following drawing shows the locations of the six Anchor Bolt holes in each P-9000LT Base.
Drawing not necessarily to scale. Not all components shown.
To anchor your P-9000LT Bases:
1. Make sure the Bases are in the correct location.
Once the Anchor Bolts are torqued into position, they are not easily removed. BendPak strongly
recommends making sure the Bases are in the correct location
before anchoring them into place.
2. Using the holes in the Bases as guides, drill the holes for the Anchor Bolts.
Note: If you prefer, you can mark the Anchor Bolt hole locations, move the Frames out of the
way, drill the holes, and then move the Frames back into position.